Specifications
• 16 or 14 gauge steel 
• Seams continuously welded and ground smooth
• Minimum-width body flange provides maximum door opening (210 degrees)
• Body flange trough excludes liquids and contaminants
• Panel mounting studs fit optional CONCEPT panels and other accessories
• Mounting holes in back of body for direct mounting or for optional external wall-mounting brackets
• Hidden hinges for clean, aesthetic appearance
• Doors are interchangeable and easily removed by pulling captive hinge pins
• Seamless foam-in-place gasket provides oiltight and dusttight seal against contaminants
• Quarter-turn slotted latch
• Door support ramp on doors 30-in. wide and wider (except window-door models)
• Four hinges on 60-in.-high doors
• Grounding stud on body
• Provision for thermoplastic data pocket (right door on two-door models)
• Hardware kit with panel mounting nuts, panel grounding hardware and sealing washers for wall mounting holes
• Installation instructions for enclosure and accessories are provided

CONCEPT single-door enclosures with solid door
• Door bar on hinge side for wire management and bonding
• Additional door bar on larger doors
• Three-point latch system on larger enclosures furnished with flush, slotted insert. Optional handles or inserts are available.

Two standard finishes are available over phosphatized surfaces: ANSI 61 gray polyester powder paint inside and out or RAL 7035 textured light-gray polyester powder paint inside and out. Optional panels have white or conductive finish.

Industry Standards
Wall-mounting brackets required to maintain UL/CSA external mounting requirement.
CONCEPT solid single-door, door with window, and flush-mount models
UL 508A Listed; Type 4, 12; File No. E61997
NEMA/EEMAC Type 4, 12, 13
CSA, File No. 42186: Type 4, 12
VDE IP66
IEC 60529, IP66